Vous ne pouvez pas modifier cette page, pour les raisons suivantes :
Documentation:
== Module Easyvr 3.0 et Arduino == # '''Pour envoyer des customs data depuis EasyVR Commander, jumper sur "UP"''' # '''puis jumper sur "Pc" pour récup le commandes custom du shield vers EasyVR Commander ...''' # '''pour téléverser sur arduino, jumper sur "SWW"''' '''Pour téléversement, mettre le jumper sur HW''' === Mode Jumper settings === This jumper selects the operating mode of the EasyVR Shield and it can be placed in one of four positions: * SW – Software Serial mode Use it for controlling the EasyVR module from your Arduino sketch through a software serial port (using pins 12-13). You can also connect the EasyVR Commander in this mode, provided that the running sketch implements bridge mode (see the Arduino library examples). * HW – Hardware Serial mode Use it for controlling the EasyVR module from your Arduino sketch through the hardware serial port (using pins 0-1). * PC – PC Connection mode Use it for direct connection with the EasyVR Commander. In this mode, the Arduino controller is held in reset and only the embedded USB/Serial adapter is used. * UP – Flash Update mode Use it for firmware updates or to download sound table data and custom grammars to the on-board flash memory from the EasyVR Commander. In this mode, the Arduino controller is held in reset and only the embedded USB/Serial adapter is used. The EasyVR module is set in boot mode. * LEO – Leonardo Update mode This is similar to the regular Flash Update mode, for Arduino boards that don’t have a separate USB/Serial adapter, such as Arduino Leonardo. The EasyVR module is set in boot mode, but the Arduino controller is not reset and it must be running the special “bridge” sketch. {{#ev:youtube|7isZb8M7yN0}}
Résumé :
Modification mineure Suivre cette page
Annuler